5151 - Honeywell System Sensor Hardwired Heat Detector (w/Fixed and Rate-of-Rise Temperature)

5151 - Honeywell System Sensor Hardwired Heat Detector (w/Fixed and Rate-of-Rise Temperature)
5151 - Honeywell System Sensor Hardwired Heat Detector (w/Fixed and Rate-of-Rise Temperature)
Item# 5151

Please Note: The Honeywell System Sensor 5151 hardwired fixed temperature and rate-of-rise heat detector has been discontinued and replaced by the 5601P model number.

System Sensor 5151 Product Description:

The System Sensor 5151 is a 100-series, combination fixed and rate-of-rise, plug-in heat detector. The 5151 detector offers superb performance and reliability in a sleek, low-profile design. Add the hardwired 5151 heat detector to most existing alarm system control panels.

The 5151 thermal detector meets the needs for applications where rapid response is vital and rapid temperature increases would only be caused by a fire emergency. The detector initiates an alarm in response to both rapid rate-of-rise conditions (increases in excess of 15°F per minute) and fixed heat (135°F). This enables the heat detector to communicate an alarm to the central control panel prior to reaching its fixed set point for high rates of rise, providing a timely response to both rapid and slow temperature increases.

Product Features:

  • Low standby current
  • Compatible with 400 Series product
  • Two visible LEDs "blink" in standby and provide a 360° field viewing angle
  • Detector head plugs easily into base
  • Built-in test switch
  • Wide variety of mounting bases with built-in shorting spring

System Sensor 5151 Product Specifications:

  • Height: 1.64 inches (42 mm)
  • Diameter: 4.0 inches (102 mm)
  • Weight: 2.8 oz. (80g)
  • Operating Temperature Range: 32° to 100°F (0° to 38°C)
  • Operating Humidity Range: 10% to 93% Relative Humidity noncondensing
  • Operating Voltage: 8.5 to 35VDC
  • Standby Current: 80µA @ 24VDC
  • Alarm Current: 10mA Min. 130mA Max. (Must be limited by control panel)
  • Latching Alarm: Reset by momentary power interruption
  • Thermal Detector Spacing: On smooth ceilings (as defined in NFPA 72), spacing of 50 feet (2500 sq ft) may be used. Other spacing may be used depending on ceiling height, high air movements, and other conditions or response requirements.
  • Sensitivity: 135°F (57°C) Fixed or 15°F/min. Rate-of-Rise

System Sensor 5151 Product Compatibility:

• Hardwired Control Panels (works universally across brands)*

* Depends upon the power availability of the control panel "brains" of the security system.
Q & A's :

comments powered by Disqus