The Honeywell 5800RP RF repeater module consists of an RF receiver and a transmitter and is intended to extend the range of 5800 series RF devices by 200 feet (nominal).
The 5800RP receives alarm, status, and control messages from 5800-Series devices, and forwards these messages to control panel connected receivers such as the 5881EN, 5883, 6128RF, 6150RF, and LYNX controls. The control then responds accordingly (arm/disarm the system, initiate an alarm, etc.).
The 5800RP also transmits it's own status including tamper, AC loss and RF jam detect via a built-in serial number assigned to a control panel zone(s). Status is sent whenever a change occurs or as part of a supervisory check-in message sent approximately once an hour.
The 5800RP contains a rechargeable battery that provides up to 6 hours of standby operation after primary power is lost. The 5800RP features a Spatial Diversity system that virtually eliminates the possibility of "Nulls" and "Dead Spots" within the coverage area.
Extends the range of 5800-Series wireless 345MHz devices
Receives alarm, status and control messages from 5800 RF devices and repeats these messages to the control panel via the primary receiver
Compatible with all 5800 wireless devices (including bidirectional, House ID devices)