The Honeywell 5869 is a hold-up switch/transmitter for a finger-operated RF transmitting device. It is typically mounted under a counter or money draw for inconspicuous operation. When the transmitter is activated, it emits an RF signal to the receiver. The security system control panel sends a burglary alarm to the central station when a RF signal is received from an enrolled Hold-Up Switch/Transmitter. Once activated, the 5869 Hold-Up Switch/Transmitter can only be reset by the reset key.
Before mounting the 5869 permanently, perform Go/No Go tests to verify adequate transmitter signal strength at desired mounting location. The 5869 Hold-Up Switch/Transmitter
should be programmed as a 24-hour silent zone type. The 5869 also incorporates tamper switches that are activated when the cover is removed, or if the unit is forcibly removed from its installation location.
No wires to run
Front and back tamper resistant
Wireless 345MHz transmitter frequency
Compatible with Honeywell 5800-Series wireless receivers and transceivers