The PROSiXMED wireless sensor is simple to activate, just press and hold the button about 3 seconds until the LED flashes. The PROSiXMED has the following LED indications; Green Flashing lights when unit is transmitting, Red Flashing lights indicate low battery (lights during button press).
To enroll the PROSiXMED, set the controller in Programming Mode, press and hold the button for about 3 seconds until the LED flashes green to activate the enrollment process. When done, the LED lights solid green for 3 seconds to confirm enrollment. Once enrolled, verify adequate signal strength by conducting a sensor test. Once enrolled, the PROSiXMED cannot be used with another system until it is removed from the current controller.
If the device is enrolled in a panel different than the intended panel, and you are unable to delete it from the unintended panel, reset the device to factory default setting: Press and hold the button for 15 seconds. When successful the LED flashes. The PROSiXMED device self-deletes from the panel it was enrolled in. This procedure is available for 24 hours after enrollment with a panel and the device remains powered (battery installed).
id:prosixmed-resideo-honeywell-home-proseries-personal-medical-transmitter|image:https://s.turbifycdn.com/aah/yhst-39386722855626/prosixmed-resideo-honeywell-home-wireless-personal-medical-transmitter-for-proseries-control-panels-102.png|name:PROSiXMED - Resideo Honeywell Home Wireless Personal Medical Transmitter (for ProSeries Control Panels)|price:38.33|rating:0|brand:Honeywell Home|price:57.49|frequency:PROSiX-Series|installation:DIY Install|wired-zones:|wireless-zones:|color:|compatible:|network:|resolution:|monitoring-type:|property-type:|communication:|supervision-test:|interactive-app:|environment:Indoor